Key cover flat key JMA WIL-5D(50+5), dierre

Key cover for keys similar to the one below:

Key head(?) dimensions 

w: ~27mm

h: ~21.5mm (measured on corner)

hole: ~6-7mm

1. Pause at 3.08mm
2. insert key (you may want to use double-sided tape on top side to make filament stick better)
3. continue printing.

If key has some engravings on top (like photo with blue one) then it may cause some over extrusion hence visible defects. To mitigate it try to scale  bottom border by one additional layer and insert pause at next layer instead of 3.08 (3.16 or 3.20 depending if you pick 0.08 or 0.12 layer size)