A1 Wyze OG

A camera mount to ride the z-axis. Mounts to the right side of the A1. Note, this is provided two ways. 1) 2 pieces which I prefer as it's easier to print, and has a locating guide to make the application of a little glue and lining up the two pieces easy. 2) a single piece, which is more complex and requires a lot of support. Note, the middle small tab at the top is very delicate as there isn't much space in between the arm that pushes the filament cutter and the cable. On mine, because I was careless, it broke off as you can see in the picture. Didn't seem to make much of a difference. This does not prevent use of the built in camera or light, though the Wyze OG also has it's own spotlight.

The camera will fit is very snug.