A1 Supplementary Lighting Bracket

To conveniently monitor printing progress on my phone, I searched the website for other creators’ supplementary lighting brackets, only to find that their designs were incompatible with the top spool and AMS lite configurations

Therefore, I designed a bracket for inverted top-mounted supplementary lighting to better observe printing in low-light conditions. This bracket does not impede the top spool or AMS lite installations, and its lowest point is positioned above the nozzle’s bottom when the x-axis reaches its highest point, preventing collisions during tall model prints

My purchased supplementary light is shown in the image on the right, requiring 4-8 M2.5×10 screws for installation

June 6th Update

A recess has been added to the lampshade's right end, allowing the cable to pass directly through the right-side bracket hole without bending