Hinge clearance is a bit tight. Couldn't get it to break loose. Worked well after glue.

Needs more walls IMHO.

Simple print that allows an accurate measurement

Printing these for Senior Center bingo prizes. They're a hit.

Nice

Nice print

Nice little print

It's tough to get everything working. I suppose that's the point...

Easy print. Glass fits a little snug. It may be modified by now to make it slide better.

Nice print. Easy assembly. Works good.

Prints good. A must have for old eyes. You can always get things plugged in correctly.

Prints better with some filament than others. Can be challenging to get the lid sliding. Toothpicks don't always dispense smoothly. Looks nice though. Find the filaments that work well and stick with those. You'll be printing several once people see this.

Couldn't find an orientation between the bottom and top that didn't trp the ball somewhere. Maybe I'm stupid... Printed well though.

Printed well. No problems. After a 2 day 4 color print, I found that these don't like full spools. I use third party filaments and one spool actually jammed the mechanism against the AMS lid. The design is such that you can remove the top part as needed. With a silica dryer system, it's difficult to remove the entire snag cutter while the silica containers are in place.

Difficult print in ASA. The design is such that it can fail easily. fairly large sections are built off of a small support. Would work better if vents were all same angle. Wouldn't look as nice but would print more reliably (at least with ASA).

Printed great. No problems. Not sure how durable the hinge will be...

printed great. No problems.

Printed great. No problems.

Printed great. No problems.