Braq - jointed Dragon

So I've printed this Braq dragon by BQEducacion several times now for family members and it was time to just post here as a remix as it takes a while to get all the parts sorted and supports painted in Studio. This is an awesome dragon but it is a project to put it together.

We prefer this dragon with the articulated mouth so that's on plate 2 as part of the build. However, I did include the standard head in an extra plate if you prefer the look of that one.

Printing Tips:

• I split the parts into 4 plates as there are quite a few pieces and this will help you label as you go and stay organized.
• I already turned down the speed on plate 3 for the middle and upper wing parts but those can be tricky to print so SLOW IT DOWN. Highly recommend for you to hit silent mode for that plate.
• Just about every single piece in this print has very little contact points with the bed, I have brims built in and I recommend keeping them on. Make sure your bed is cleaned or prepped well for maximum adhesion.

Assembly:

• 2mm Elastic cords
• Needle nose pliers(or similar to help grab cord through the parts.
• Below is the Youtube for assembling and a photo so you can get an idea of the printed parts to prepare for the assembly process.