Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
1
3
0
0
7
7
Released
Description
This was inspired/remixed from Jhead's case. I didn't like having a screw in the front and the board screw holes were a bit off of center. I reinforced the front wall and labeled the audio ports and power (I could never remember which was "in" and "out"). I changed the case screws to go through the board screw holes and removed the holes in the top. Takes four 10mm m3 screws.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)