Great design! printed without the snow

works nice and assembly is without much issue. just needed to go back and forth a bit to fit the plates together, but once done it works like a charm. I'm also trying to print now more stacks (but now two per plate, see if it works).

just beware that this might not fit into 3d printed spools, but for that i use a remix with a smaller version that fits the pinholes without breaking.

the only bad thing is that the hat ended up being too heavy for my cat to use it properly

printed nice, used two colours (manually switched). Still need to reprint the Xp and HP tokens in the proper colours.

printed fine. only the water bobber that had a bit of issue, but nothing that lead to any issue in the final model. maybe this piece would be best printed separately, but I'm not sure.

printed without issues, but it is not water tight (not sure why I thought it would be ^^)

works perfectly

got a small shrinking that could have been solved by adding some brims to the frame pieces. the back parts printed alright. I also changed later on the portrait holder to a ikea skadis pin, so now it looks nice in the board.

Great, and fits nicely in my place

almost perfect, but got some bad adhesion on pla

perfect, already printed two of these

nice

I'm not sure if its the ruber band that is a bit too soft but I found it a little hard to get it to fly (or anything similar to it). Managed once though (for a very short flight)

worked perfectly for me. just changed the size a bit to fit my needs.

had some issues getting the internal clock components to fit the groove, but still works nd looks fine.

almost perfect, but the issue was on my end, my knife was just a little too big, and I didn't realised

perfect

works OK, but the pegs were a bit hard to fit in the board.

fits great