Printed perfect, very useful!

Deforms easily, but that's expected. Still very useful despite the limited lifetime, it is quite strong once the thin edges wear off.

I made a setup with 3 of these dryboxes, very satisfied with the result. Maybe one change that would improve the design is a tighter fitting lid for the silica beads.

Printed a pair for my friend's headphones, the swivel joint was already completely fallen apart. I added two wings to prevent the zip tie from sliding off, I'll probably upload my version as a print profile. After two weeks it is still holding up great.

Great design, I wouldn't recomment printing it in transparent, since both the bottom and top parts are in two pieces, glue is going to make it ugly.

Perfect

Very useful with the swivel stand, the joint is a little bit loose, but I might be able to tighten it later

Perfect print for my bathroom

Seals good

Solid, no bed adhesion problems

Solid

Makes a great organiser for my desk

Works good

Works good

This is clearly :) a good profile!

Added silicone feet, very solid solution

I kind of frankensteined it together from the other print profiles, came out great

Very solid

Had a bit of bridging issue with the infill and top shell, but that was because I used 3d cubic to make it more squishy.

10/10 models I had trouble printing the upper finger grips, went through 3 attempts before figuring out the issue. Was my first time printing TPU (bambu 95a HF) and the default preset had WAY too fast print speeds. I was considering the pinky rest grip, but since I thumb I found the pinky shelf slightly too high. Might come back to this later though and try it out