This works freakin amazing! Word of warning - if you have a corded saw don't go full tilt on the speed or the blade will break sending the shaker flying with the extra weight of the paint can and cause it to break in half when it hits the concrete. Don't ask how I know ;) Glued it back together, replaced the blade, and went about 50% speed and my paint was so dang smooth and well mixed with 0 effort output. Well done!

Love the look and feel. Most of my allen keys didn't fit quite right but I did find some that did fit. They all work great but my M3 one broke the first time I used it because of the torq on the bolts. I feel like M3+ the bolts start getting too large / too high torque for these to hold up. It did glue back together ok and i've still got it and will try it again in the future. Might just be me / the material - Printed in Bambu PETG-HF

Was looking for one of these for the rubber tipped air guns. Printed perfect. Fits the rubber tip well. Haven't tried it yet but my bottle of wd40 is getting a bit low... :)

Have these in all of my boxes and they work perfect and have held up great. Easy 5*

Was able to condense so much into 1 slot and freed up a lot of wall space. I want to print another it's so good but don't have enough stuff to justify it ha! Printed in PETG - hoping it holds up :)

This is the one you're looking for! I've tried a couple of the other utility knives and a lot of them are soooo light duty they are just toys. Finally found one that looks good, functions well, printed perfect, and I can beat up in normal day to day use! Well done.

I need one of these the entire size of my build plate now!

As a fidget toy its a lot of fun. As a useable knife it not so great. Tried to use it twice - first time to trim a stem off of a plant and the second time stripping a wire and both times the utility blade popped out immediately. still a great design and the magnetic version works great. PETG-CF

mine didn't click but it's a very snug fit. just what I needed!

Fits and looks amazing :) just what I wanted! Don't forget that the correct orientation is with no lines vertical or horizontal! The right hand line makes the side of a slanted A for Aperture :)

Finally have an entire drawer back from these guys!

Power supply fit and sits perfectly. Had to manually open up the holes some so my wood screws would sit flush enough to not scrape up the back of the power supply.

Printed in black PETG and it fit perfectly

Printed in TPU - fits like a glove!

Worked perfect the handful of times i've used it so far. Highly recommend

It wouldn't hold still on any of my cabinets with the hook in the back. When trying to take the towel off it would just pull the entire thing off. Nothing wrong with it, it's just not designed for my cabinets. Ended up cutting the hook off and used double sided tape to attach it next to the sink. Holds amazing once you get the feel for inserting the towel. If you use too much force when using the towel you will bend the device and pop the printed ball out but this only happed in my "testing" so far and not in day to day use. Great design and I will be printing more of the non-hook versions to use around the house.

Perfect fit and holds lots of desiccant. Don't make my mistake and print them in PLA and put in the ASA rolls forgetting they are made of PLA then dry them into mush :D

Printed in ASA. Best one i've tried so far!

These work amazing! The only drawback is you can't use them when drying a fresh roll in the AMS because they stick out too far. Need to print out some of the low profile ones next for this purpose :) Would also highly recommend the holder for these guys it is perfect as well.

I got 8 feet i'm gonna use all 8 feet! Been using them for about a month now and not sure if I can tell a difference but I love it!