xtouch case for p1 series printers. Design allows for sd card to be inserted and removed easily, indent for chamber temperature sensor to be plugged into the board and cable routed to the printer. It can be powered by either the supplied connector or usb c right angle cable which can also be routed through the mount as shown in the pictures.

The tolerances of the back cover should be good enough to create a friction fit with the front cover requiring no screws however the holes are there.

The mount support itself was sourced from xPitax model. You will require 2x m3 screws to secure it to the back cover. Nuts shouldn’t be necessary as it should screw into the mounts plastic.

Printed on a wham bam PEX plate for the gloss finish at 0.16mm layer height. Will work with any plate though.