Part 1 File - Kal's mount was a good solution for mounting the xtouch / p1touch however being on a lower table I needed a harder angle to see the screen better. I also trimmed a little off the front to clear my BU Faceplate and added holes for holding the 2 allen wrenches and 2 slots for SD Cards, cuz why not. It can still be printed in the same orientation as the original with no supports, but a little brim would help bed adhesion.

Part 3 File - The original frame wouldnt allow the module to slide in with an SD Card inserted and XTouch was telling me to insert one when tried booting it without it so I added a notch for the SD Card. I extended to notch to include the input plug next to it for those who wanted to add the chamber temp sensor and run the wires out of the same usb plug hole so I didn't have to edit the Part 2 file at all.

Mount clears JJDeluxe's lid raiser