*Apple AirTag Keyring Case Print in Place by mediaman3d

mediaman3d

Fashion>Other Fashion Models

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 6 walls, 100% infill

33 min

1 plate

4.1(9)

Stronger 0.2mm layer, 6 walls, 100% infill

25 min

1 plate

4.3(3)

Open in Bambu Studio

Boost

161

195

Released

Description

This is a AirTag holder that is print in place. No assembly required! It is designed using an AirTag model based upon Apple's dimensions of 31.9mm X 8mm and photos available since the announcement.

This has been successfully printed and tested using a 0.1mm layer height. A 0.15mm layer height should also work, but I expect that a 0.2mm layer height could prevent the hinge from working.

For a more refined AirTag keyring case, check out my AirTag Twist-Lock keyring case on MyMiniFactory:
https://www.myminifactory.com/object/3d-print-airtag-keyring-twist-lock-case-167136

Comment & Rating (15)

@dv.o_danonescu

Print Profile

0.08mm layer, 6 walls, 100% infill

a little bit large

The designer has replied

@jordanwilliamki

Hi. Thanks for the feedback. I have had other say it is too small. Clearance can vary a little by machine and where this has to fit snug that little bit of difference can make some too small and some to big. I hope it still worked ok for you, and thank you for contacting me.

@dv.o_danonescu

Replying to @jordanwilliamki :

It's ok now.I increased a little by scaling and the next print was fine

@Seldur

Print Profile

0.08mm layer, 6 walls, 100% infill

Soweit gut aber ich werde die Oberfläche versuchen etwas zu glätten.

The designer has replied

@jordanwilliamki

"Vielen Dank für die Information. Bitte lassen Sie mich wissen, wie das fertige Stück nach dem Glätten für Sie funktioniert (Ich habe einen Übersetzer benutzt, falls das keinen Sinn ergibt. 😊)"