Quick Clamp by LoboCNC

LoboCNC

Tools>Other Tools

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 5 walls, 50% infill

4.2 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

Released

Description

This 110mm light-duty clamp uses a quick-adjusting rack & pinion to open and close the clamp, and a spring-release ratchet to hold the clamp shut. It prints with minimal supports and requires no additional fasteners.

Print Settings

Printer:

UDIO

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2mm

Infill:

30% (triangular)

Notes:

Print with 4 perimeter lines (0.4mm wide) for greater strength and stiffness. Print two of the pad parts and one each of the body, jaw, gear and pawl.

Post-Printing=============

After printing, sand down any blobs or lumps on any of the mating surfaces. Using a little Vaseline or light grease on the moving parts will make it operate more smoothly. To assemble, first insert the pawl into the hole in the side of the moving jaw. Then insert the gear into the key-hole shaped slot in the jaw and slide it up towards the pawl. Then slide the moving jaw onto the body. Finally, slide the pads into the dovetail slots on the jaws. Rotate the knob CCW to clamp, press the release lever and rotate the knob CW to unclamp.

Category: Hand Tools

clamp

thingiverse

clamps

Comment & Rating (6)

@user_3347049795

Superbe création , seul defauts sont les patins qui sont un peu mal realiser et ne tiennent pas bien en place . si je les colle ils ne seront plus interchangeables. J'aimerais en avoir en PETG et en TPU .

@user_614915116

Boosted

Print Profile

0.2mm layer, 5 walls, 50% infill

good works well I have 2

@user_614915116

Boosted

like this print verry easy to use I printed 2

@Hoverhy

It's easy to clamp my tool! Like yor design, just use petg or ABS filament is fun. You can also make it 5 wall and 50% fill to increce strenth. be ware of two pad parts, the file only offered one pad parts, need clone one.