spoolholder for honeycomb Remixed by Willi 3D

Remixed by

Willi 3D

Tools>Organizers

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Spoolholder for Honeycomb

Designer

3.2 h

2 plates

4.9(39)

Boost

141

265

236

Released

Description

This is a spool holder for the honeycomb wall system from RostaP. This is compatible with my [BaBo duo] riser modul in the honeycomb version but also for any other application with honeycomb wall system. Printed bearings in size DIN625-608 are included, but you can also use real ball bearings if you have them.

There is an additional filament guide that works with the Bambu Lab connector. (See image.)

Optionally, the spool holder and the filament guide can be screwed to hexagonal plates from the rear.

Big thanks to printingbuddy for testing.

Comment & Rating (50)

@CADKrieger

Print Profile

Spoolholder for Honeycomb

Es fehlt nur noch der Schlauchanschluss. Hier nur eine Notlösung 😄

The designer has replied

@Willi3D

Solange es funktioniert, ist es super. :D hehe

@guido.nowatzki

Boosted

Extrem nützlich und passgenau. Daumen hoch dafür Willi.

The designer has replied

@Willi3D

Danke 🫡

@sweatbox

Worked super. Had to rotate the roll a couple of times with hand before it goes well alone with a spool, but now it works great. Roll is pla bambu silver Bearing and housing petg Grey from sunlu. The bambu petf fitting sits perfect on the arm. Used a petf free y splitter in the back, so I don't had the mess around in the back anymore (except maintenance) Thanks for designing and sharing.

@3dnyc

Print Profile

Spoolholder for Honeycomb

Another impressive piece. Just printed two of the main piece for storage of spools, not for active use. I can hang 2 spools on each.

@danghaihuynh89

Print Profile

Spoolholder for Honeycomb

Works great. I printed with 0.6 mm nozzle at 0.42 layer height so the fit was exact but didn’t have any wiggle room to allow for rotation. It is very strong and printed without supports. I think using a 0.4 mm would have led to a much better fit and room for rotation. Overall good design.

(Edited)

@nookie

Print Profile

Spoolholder for Honeycomb

@BlasterXD

Print Profile

Spoolholder for Honeycomb

doesn’t roll good enough. tolerance too tight. Il have to look at it some more and see what I have to do.

The designer has replied

@Willi3D

Did you use the printed bearings or real ones? I would be happy if you could get it working and report back.

@BlasterXD

I used real bearings.

@scott.reiser

Replying to @Willi3D :

I printed this in PETG and cleaned up the edges of the roller and the printed bearings. Rolls just fine for me. Thanks for putting this out @Willi 3D.

@user_524518948

Print Profile

Spoolholder for Honeycomb

Perfekt, danke für's bereitstellen