Place for your nozzles in a familiar shape! Just two easy-to-print parts.
There is place for 36 nozzles in total - 6 of each size (0.25, 0.4, 0.5, 0.6, 0.8 and 1.0). You can also put one of your nozzles to the “hotend” :)
Printing instructions
- Part 1
- Use 0.2 layer height or less with 20% infill
- It does NOT need any supports
- GO VERY SLOW ON THE FIRST LAYER.
- Part 2
- 0.2-0.24 layer height with 20% infill
- You need to use supports only for the “legs” that will go into part 1
Assembly instructions
- Just insert part 2 into part 1. I made the tolerance very forgiving so everyone can print it with any device, because of this you might need to use superglue to hold it in place properly and permanently
- The "hotend nozzle" can be screwed in or again - superglue
If you need anything, feel free to send me a message and I will try to help you out!
My Twitter :)