Bambu Spool for A1 Mini
Remixed by
Copyright Claim
Bambu Spool for A1 Mini
Remixed by
Boost
161
324
51
Print Profile(1)
0.2mm layer, 5 walls, 15% infill
Designer
9.6 h
2 plates
Open in Bambu Studio
Boost
161
324
51
9
618
356
Released
Description
I just wanted my printed spools to look closer to the spools I got from Bambu and to use a little less material. So I added holes into the spool and I also added a banana clip to hold the filaments end. It might have been better for me to print the clip separately and add it in later but I liked this style for now. This is my first attempt at doing anything with 3D models so Ive probably made some mistakes but it did print for me without issue.
Comment & Rating (51)
All
Print Profile
0.2mm layer, 5 walls, 15% infill
print quality isnt super impressive. could be my filament. but the design is also not 100% accurate in my opinion.
1
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
worked perfect, I even love the unfinished walls showing exposed gyroid. loaded up bambu red PLA basic and the nfc chip even worked
1
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
Great quality, works just like reusable Bambu lab spool
0
Reply
gloss gold love it looks amazing thx
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
Good quality, printed well. A bit flimsy towards the edges, but not ad.
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
Great print
0
Reply
so this would work with the refill filaments from bambu correct
The designer has replied
0
Reply
Correct this is just a re-mix of the official model from bambu to fit the A1 Mini and look close to their shipped spools.
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
The bed adhesion.
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
hard to print
0
Reply
Boosted
Print Profile
0.2mm layer, 5 walls, 15% infill
Ottimo setup. Con A1 mini stampato senza problemi
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld