New to HueForge and using the AMS but created this as a test print to try. I am a Clemson fan but was going to make this for my father in law and wanted to share with any other Alabama fans that are out there.

I made it decently thick so it wasn't floppy and wouldnt be damaged when removing.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA PolyLite Pro Black Transmission Distance: 0.3
PLA PolyLite Pro Red Transmission Distance: 1.5
PLA PolyLite White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #28 (2.32mm) swap to Red
At layer #31 (2.56mm) swap to White for the rest.