Do you want to print a snowman? (Olaf Wobble)

Cartoon Snowman wobble figure. Everything printed in parts and assembled - no AMS required.

Remember to also print his snow baby friends!

Parts

Glue and weights of your choice:

• Copper coated BBs
• Copper bearings
• Tungsten bearings

Instructions

1. The placement of the eyebrows, eyes and buttons should match how they should be placed on the body. Use a little glue to hold the pieces in place
2. Check the orientation of the buttons before you glue it in to make sure the orientation matches the hole in the body.
3. Place some weights in the bottom cavity before capping it with the circular cover.
   1. Ideally they should be held towards the bottom/center of the base.
   2. You can loose change, BBs/bearings like I list above, or other weights of your choice.
   3. To keep the weight centered you may need to add padding in the cavity before capping it. You can use some paper towels, cotton rounds, or other material of your choice.
4. Install the base into the body.

Other Wobbles

Uses the same weighted base

If you're feeling generous and like what you see, Buy Me a Coffee or Send me a tip.