Wobbly Snowman

Snowman wobble figure. Everything printed in parts and assembled - no AMS required.

Parts

Glue and weights of your choice:

• Copper coated BBs
• Copper bearings
• Tungsten bearings

Instructions

1. The placement of the eyes and buttons should match how they should be placed on the snowman. Position the eyes, nose, mouth, and buttons through the bottom from the inside and press firmly. They should pop snugly in place without any glue.
2. The colored ring around the hat requires a small amount of glue to hold in place. The hat will also require a little glue to attach to the body
3. The two halves of the scarf will also require a small amount of glue to attach around the neck.
4. Place some weights in the bottom cavity before capping it with the circular cover. 
   1. Ideally they should be held towards the bottom/center of the base. 
   2. You can loose change, BBs/bearings like I list above, or other weights of your choice. 
   3. To keep the weight centered you may need to add padding in the cavity before capping it. You can use some paper towels, cotton rounds, or other material of your choice. 
5. Press the circular cover over the weights and press the edges to snap it place.
6. Install the base into the body.

Other Wobbles

Uses the same weighted base

If you're feeling generous and like what you see, Buy Me a Coffee or Send me a tip.