Heyho :)
Greater Update 27.12.202: V2
I redesigned the Glasses & Inlets for a sturdier fit and an easier assembly!
Addon 28.12.2023 Hinged temples: 2 Versions: Print in Place & Pin in Place .)
https://makerworld.com/de/models/111725
---------------------------------------------------------------------------------------------------------
I had some glasses printed for a party this year. I didn't like the poor fit, rattiness or the fact that most of the models kept falling off or breaking quickly.
That's why I sat down and designed my own. This one is designed for FDM printing and doesn't need any extra parts or reworking.
The only "disadvantage" is that you can't close it. However, closed glasses don't look good at parties anyway :D So it's better to pass them on and share them if you don't want to wear them anymore!
Slim Inlets:
I added some slim inlets. They are naturally not as strong and durable as the normal inlets but strong enough and will improove the sight if you use denser Infill.
Customization:
You can print the lenses with the infill of your choice! I recommend not choosing a pattern that is too dense so that you can still see well :D 15 - 20% is usually enough!
To see the infill only set the Top and Bottom Layers to 0!
Scalability:
You can also scale the glasses to make them fit even better! For my daughter, for example, I reduced the width of the glasses in the slicer by 18 mm so that they fit better! (Scale all 3 axis at the same factor!)
Printing tipps:
I used PLA, 3 Perimeter, 25% infill with the temples and 100% Infill with the main body. Glow in the Dark will look cool too! If you have problems with breaking parts you can also use tougher materials like PETG.
Assembly:
All parts are designed for a stable press fit. The temples have to be pressed into the glasses with quite a lot of force and then hold very well! If it doesn't work at all, you can also scale the temples a little smaller and reprint them.
The assembly of the brackets in the main frame requires some force. Especially with stiffer materials such as PLA. To simplify this process, you can apply some candle wax to the locking mechanism to make insertion easier. The brackets still lock very firmly.
Post processing:
Not really necessary. But if you really want to go all out, it's certainly worth joining all the parts together with a little superglue.
If there are some sharp chamfers you can trim them off with a deburring tool or a knife :)
Heat it up :)
You can also heat the end of the frame up to fit it even better to your geometry. Use a heat gun or carefully use a lighter.
Stability:
The Glasses should be very stable even if printed in PLA:
Have fun and a happy new year! :)