BMW Coaster printed face down Remixed by Fauxtool

Remixed by

Fauxtool

Household>Decor

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 10% infill

Designer

40 min

1 plate

5.0(1)

2-pack

Designer

1 h

1 plate

Open in Bambu Studio

Boost

Released

Description

I flattened the original model's face so it sits more flush with the build plate and so that it can bee printed face down. Turned off elephant foot comp and added arachne wall generation for better color separation and sharper font. It looks wrong until you slice it, but it prints fine. Bottom Shell layers reduced to 2 to cut down on color changes. Top layers are white so the colors show better with less layers. You can crank up the speed after the first 2 layers. This is a fast and cheap print

Printed in a mix of Bambu PLA and Sunlu PLA+ on the smooth build plate for appearance. This does not need a brim.

Be careful when scaling up that you keep the same thickness.

Resize to 67mm for some perfectly fitting cupholder inserts on a BMW f30-f36

Comment & Rating (5)

@hubuki

Print Profile

0.2mm layer, 2 walls, 10% infill

bmw

The designer has replied

@Fauxtool

very nice, even better color separation than my test print. Default settings or did you change the line thickness?

@decreedo

Why is it made from two objects that overlap each other? This could lead to many failures and problems. Additionally, in the print profile, there's a colored picture, but it's not reflected in the actual print. The print profile should be ready for one-click printing. Not printed, but i would rate it like 1/5.

The designer has replied

@Fauxtool

You are simply wrong, try it before speaking. Read the description. All your concerns were already addressed Unless you own the exact colors that the maker does and in the same slots it will never be a 1 click print. You are being totally unreasonable and your ignorance is unbelievable

(Edited)