This is an extension for the Tools and Accessories Box

Since the model was very easy to print so far, I wanted to continue this here as well.

Therefore this extension consists of two parts which are held together with 8 magnets 6x2mm.

The magnets do not have to be glued in but are held in place by a form fit.

Both parts are needed because the distance to the top must be adjusted so that the extension can be used.

Likewise, both lids still fit on this extension, the original lid and the new lid for the complete hotends, both close flush.
The fit has also been improved so that both covers hardly wobble when they are fitted.

The following parts can be stored:
- Activated Carbon Air Filter
- Filament holder when not in use (AMS)
- ProClip filament clip (link)
- Two freely usable compartments