Print Profile(1)
0.08mm layer height, 0.16mm first layer height
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
18
37
6
0
54
12
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Protopasta Black Transmission Distance: 0.5
PLA PolyTerra Army Blue Transmission Distance: 0.3
PLA Creality White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Army Blue
At layer #11 (0.96mm) swap to White for the rest.
Comment & Rating (6)
All
Print Profile
0.08mm layer height, 0.16mm first layer height
Je pense que j'ai pris des couleurs trop foncées du coup le rendu est bien trop silbre
The designer has replied
1
Reply
Same as the other reply to the other comment stating that, I tried my best, but the platform wouldn't let me upload the model with more definition, because it was taking too long on their end to slice. Maybe I'll try to find the raw file and place them under the profile, will see if I find it.
0
Reply
I would revise the model to give more definition to the mosasaurus face. The model has some real promise.
The designer has replied
0
Reply
Maybe add a 4th color gray/silver to define the mosasaurus more
0
Reply
Well, the original had more definition, but MakerWorld wouldn't let me post it because it took too much time to slice it on their end. I've never had this happen before, so I had to smooth the model a bit for it to upload. See photos for reference.
0
Reply
Print Profile
0.08mm layer height, 0.16mm first layer height
Other Issues:horrible. don’t print. wasted my filament. I’ve never had this issue before.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld