PTFE 90º angle cutter with view line

Remixed by

PTFE 90º angle cutter with view line

Remixed by
Boost
14
39
37

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
26 min
1 plate
4.9(34)

0.2mm layer, 2 walls, 5% infill
0.2mm layer, 2 walls, 5% infill
23 min
1 plate

Open in Bambu Studio
Boost
14
39
37
4
98
96
Released

Description

Remix of sagatxxx model. I liked the design but I wanted to be able to view the tube for precision cutting to length.

Comment & Rating (37)

Please fill in your opinion
(0/5000)

Boosted
Thank you for this good design. Printed without problems, works very well.
(Edited)
0
Reply
worked well
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
worked well
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed nicely! I do wish the viewing hole was a little bigger though. I took off one star because the ptfe tube isn’t secure inside the cutting jig - maybe a stopper at the end or a small clamp would help the model?
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
works!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Good simple cutter
0
Reply
Printed great, very very useful! Thank you.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed great in eSun PLA+
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
great little cut guide
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply

This remix is based on

This source model was used for remixing/sharing before its license was restricted.
PTFE 90º angle cutter

License

This user content is licensed under a
Creative Commons Attribution-Noncommercial