Improved Y-splitter for A1 series with AMS lite
Copyright Claim
Improved Y-splitter for A1 series with AMS lite
Boost
22
41
6
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
22
41
6
0
53
33
Released
Description
Improved splitter with smoother curvature to reduce friction and risk of jamming. It takes 4mm PTFE tube from bambu, and the other end goes straight into the printer. The clip on top of the splitter will hold the other tubes.
Please use the small hex key to remove any string in the tube.
Comment & Rating (6)
All
Splitter broke inside ptfe "hub". I had to dissasembly all to remove. :-(
The designer has replied
0
Reply
!! sry to hear that!
Were you using petg?
And was it stuck because the OD is too large? Or it snapped during a print?
I can make an update if you have any suggestions:)
0
Reply
me too...
0
Reply
Thank you! Can I get that tiny little clip you have on top of the two tubes also?
The designer has replied
1
Reply
Welcome!
The clips are from Michal, please see the link below:
https://makerworld.com/en/models/492648#profileId-417415
Printing without brim should be fine.
0
Reply
Also, I'm making some y-split improvements if you want to check them out, I'll include them in the remix.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld