AMS Riser Filament guide
Remixed by
Copyright Claim
AMS Riser Filament guide
Remixed by
Boost
24
68
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
41 min
1 plate
Open in Bambu Studio
Boost
24
68
14
1
89
29
Released
Description
I designed a filament guide to match my AMS riser filament holder
can be screwed to the riser using 2x M4x10 screws with washers
Comment & Rating (14)
All
Printed with Sunlu PLA+ and I am very happy with the result. Thank you for your work!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed using "Control 3D Basico PLA".
All OK
0
Reply
here it is...
0
Reply
this is not working because you can not put the glass back..
You could use some threaded inserts
(Edited)The designer has replied
0
Reply
I don't know why it shouldn't work. Either your screws are too long or if you don't have a shorter one you have to use several washers
0
Reply
Replying to @duck.knapp
Then I'm doing something wrong I think... do you have some pictures how you put this together ?
0
Reply
Replying to @Dutchapple4life
That's not possible right now.
Again, I don't understand why it shouldn't work...
Just screw the screws into the riser and everything fits. You just have to make sure that the screws don't look inwards.
no nuts or anything, just use M4 in the plastic and you're done
You are welcome to take a picture of the inside and outside so I can see what the problem is
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
passt
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld