kannst du bitte mehr Infos für das Teil geben? Ich sehe ein PFTE Schlauch, aber was ist unten noch für ein Teil (knapp zu sehen), damit AMS den PTFE Schlauch überhaupt aufnehmen kann? Wo gibt es das?
Will this help an AMS lite? I have repeated filament not loading errors with Bambu glow-in-the-dark, and their light blue PETG. it’s like it sticks to the side of the spool.
I'm not sure if it works with the AMS Light. I have only tested it on the AMS of the P1S. It depends on a trial. I would appreciate some information on this.
printed very well
after often getting filament stuck because it was wound too tightly on the side of the roll, I'm going to try this tool ... thanks to its simplicity I'm confident that it will help :)