The Button
Copyright Claim
The Button
Boost
44
81
29
Print Profile(2)
0.24mm layer, 3 walls, 18% infill
Designer
44 min
1 plate
A1 mini 0.24mm layer, 3 walls, 18% infill
46 min
1 plate
Boost
44
81
29
0
198
163
Released
Description
The Button is the main part of my series I will build on.
Housing and the spring inside is print-in-place. The cap will be pressfitt.
Extensions will be released based on the housing and will replace the cap.
You can already see a release mechanism in the spring wich allows me to add even more add-ons.
Once the print is finished, you just need to press the button hard once and it will release itself from the bottom.
Now you can press the button over and over again.
If you have any ideas on what I could built on top of the housing just tell me in the comments (need some feedback)! :-)
Happy printing!
You can check my other fidget switch here:
https://makerworld.com/de/models/62914#profileId-65584
Comment & Rating (29)
All
the button design was a good idea, however the button refused to press and after it did, it got stuck inwards and could not come back out. I don't know if it was the printer or the download.
0
Reply
Print Profile
A1 mini 0.24mm layer, 3 walls, 18% infill
printed great, after a hard press the button works!
0
Reply
Print Profile
0.24mm layer, 3 walls, 18% infill
i use it a lot its great
0
Reply
Print Profile
A1 mini 0.24mm layer, 3 walls, 18% infill
It kinda worked kinda didn't for me.
0
Reply
Print Profile
A1 mini 0.24mm layer, 3 walls, 18% infill
it warped up a bit on the first print with petg, switched over to pla and it worked
0
Reply
Print Profile
0.24mm layer, 3 walls, 18% infill
Good button. Favourite so far
0
Reply
Print Profile
0.24mm layer, 3 walls, 18% infill
Not the button feeling i expect
(Edited)0
Reply
Print Profile
0.24mm layer, 3 walls, 18% infill
Kid loved it. Shes pretending it to be labrats cheesenado button.
0
Reply
Print Profile
0.24mm layer, 3 walls, 18% infill
Great print. Love the concept.
0
Reply
Print Profile
0.24mm layer, 3 walls, 18% infill
liked it, hard to do the first push and required me to put on floor and step on it until it popped loose then worked well
(Edited)0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld