Underdesk Keyboard Holder (customizably with)
Underdesk Keyboard Holder (customizably with)
Boost
29
31
5
Print Profile(1)
Underdesk Keyboard Holder - 0.24mm layer, 2 walls, 30% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
29
31
5
0
69
54
Released
Description
I made a simple underdesk keyboard holder for each keyboard in terms of width. However, it must not be higher than around 33.5 millimeters in height, check first.
I printed in PLA with 0.24mm on textured PEI and 30% Infill, but I think the Infill can be chosen a little bit lower.
Comment & Rating (5)
All
That's pretty cool for this holder, and I'd wanna know which is the key board manilfactilrer and the model
(Edited)0
Reply
Print Profile
Underdesk Keyboard Holder - 0.24mm layer, 2 walls, 30% infill
0
Reply
Print Profile
Underdesk Keyboard Holder - 0.24mm layer, 2 walls, 30% infill
0
Reply
Print Profile
Underdesk Keyboard Holder - 0.24mm layer, 2 walls, 30% infill
0
Reply
Print Profile
Underdesk Keyboard Holder - 0.24mm layer, 2 walls, 30% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld