*New* AMS stacking stand for Bambu Lab P1P and X1
Copyright Claim
*New* AMS stacking stand for Bambu Lab P1P and X1
Boost
71
140
12
Print Profile(1)
0.2mm layer, 2 walls, 8% infill Draft
15.7 h
2 plates
Boost
71
140
12
6
331
83
Released
Description
This will not fit the older AMS models! Please check!
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 8% infill Draft
nice!
0
Reply
si può posizionare sulla X1?
in modo da avere 2 AMS sulla X1?
grazie
The designer has replied
0
Reply
Yes
0
Reply
but might be close to edge
0
Reply
Replying to @TripleGWorkshop
si potrebbe modificare in modo che si possa adattare perfettamente alla X1 cosi da montare 2 ams? grazie
0
Reply
Nice, I just printed the original ones only to realize they didnt fit...
Back on here and found yours..
Is there any difference in the 2 plates?
I will take some snaps once they are printed and update the post.
The designer has replied
0
Reply
One set is full width and one is more minimal
0
Reply
Boosted
merci
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill Draft
Good print, however, the model is a bit wobbly
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill Draft
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill Draft
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld