15 The Puzzle Game by warlogh

warlogh

Toys & Games>Puzzles

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 4 walls, 40% infill

Designer

40 min

1 plate

4.9(7)

0.2mm layer, 4 walls, 40% infill

Designer

26 min

1 plate

4.0(4)

0.2mm layer, 3 walls, 50% infill

Designer

1.6 h

2 plates

4.0(4)

Open in Bambu Studio

Boost

118

Released

Description

15 Puzzle Game. Quite simple, easy to print with no supports. Full size including Lid is 67x67x10mm

Who is not familiar with this game, rules are pretty easy. You have to get all playing buttons in order by sliding them using a single empty spot.

There is 2 different sets of buttons presented. One with deeper numbers and other with very close to surface (which I use for multicolor print). If You can use a 3mf files, I have made 3 Bambu Studio 3mf profiles. If You are printing from STL files I suggest to use an Ironing on Base for smoother and more sliding surface.

You can Buy me a coffee if You feel good doing so :) (And very big Thank You For interest in my work)
https://www.buymeacoffee.com/warlogh

Comment & Rating (19)

@lordkeeper

Print Profile

0.2mm layer, 4 walls, 40% infill

(Edited)

@user_3761828279

Print Profile

0.2mm layer, 4 walls, 40% infill

@user_3761828279

Print Profile

0.2mm layer, 3 walls, 50% infill

@user_3761828279

Print Profile

0.2mm layer, 4 walls, 40% infill

@oky_

This model is bad. I printed the AMS number and the holder and the numbers didn't even snap into place and if i tip it over, It falls out.

The designer has replied

@warlogh

Hmm, sorry to hear you didn't like it. But if I understand you right, then look like you are looking for a bit different style type of this game. This model is not designed for snap in numbers. this is more like traditional old style with box with a Lid. so with a lid on nothing will fall out. I tried to make a version with a number buttons connected (like snap in) but didn't like the outcome so at least at a moment this idea is detained at least for a while

(Edited)

@oky_

Print Profile

0.2mm layer, 4 walls, 40% infill

Other Issues:The square to hold the numbers is too small so the numbers will fall out.

The designer has replied

@warlogh

I thought I explained to You that Numbers are meaned to b a bit loose. It is for easy moving. Especially regarding on different tolerances on different printers. But Why I'm here back to You it is because I'm A bit confused as This rating is not on Holding Box (square) profile, but on Lid profile. So question is, have you printed all 3 parts (Numbers, Box and Lid) or You are trying to use a Lid as a Holding Box (Square)? Probably my fault is that I made a separate profile to each part and it is confusing . (as it was one of my early projects and I'm still learning)

(Edited)

@oky_

I just printed the numbers and wait is the thing that holds the numbers to move supposed to have two semicircles on the side of it? it just hit me I don’t think I printed the part that holds the numbers, I think I printed the lid. if this is the case, sorry for the review.

@oky_

Print Profile

0.2mm layer, 3 walls, 50% infill

Other Issues:Numbers too small, so they don't fit