a1 mini ams lite spool
Copyright Claim
a1 mini ams lite spool
Boost
34
81
23
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
3.9 h
2 plates
0.4mm layer, 2 walls, 15% infill
3.3 h
2 plates
Open in Bambu Studio
Boost
34
81
23
1
219
233
Released
Description
a1 mini spool for ams lite
about 1kg should be placed
compatible with a1 mini ams lite
good for refills
Comment & Rating (23)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
way to tight fit, used plenty of lubrication. broke before fully screwed in. E-PLA
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super zu drucken und passt perfekt.
0
Reply
Good but need to honed a bit
0
Reply
just add some oil or grease for the first contact
1
Reply
printed with .4mm and had a tougher time getting the tolerance right. still a usable print with some sandinh
The designer has replied
0
Reply
just add some oil or grease for the first contact
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
to tight hard to put together
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
set layer height to 0.16mm. works fine
0
Reply
Print Profile
0.4mm layer, 2 walls, 15% infill
I'm new to printing. The female end had bad threads, lots of crossed threads and bad layers. I ran my mini at 50% with bambu basic PLA, so it could be operator error
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints well and was easy to assemble. no need to lubricate or sand.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
genial... funciona perfecto
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld