AMS lite spool holder lock
Copyright Claim
AMS lite spool holder lock
Boost
133
189
20
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
133
189
20
12
117
77
Released
Description
This model is for those who (like me) are having problems with some spools falling out of the AMS during long prints.
These are two small parts that do not affect the original movement, print quickly and use very little material. I tested PLA and PETG and both worked well, but I prefer PETG because of the friction of the parts.
For the spools I use, the smaller 1cm locking pin is sufficient. However, I also added a larger 2cm pin to the model to fit different spool sizes.
Instructions
I will leave two videos showing how to assemble and use the parts.
Hope this helps :)
Comment & Rating (20)
All
Boosted
Since I've got my A1 I've printed many many AMS lite lockers and this is by far the most reliable and sophisticated solution I've seen! Thank you for this! Printed flawlessly! Printing the other 3 now!
The designer has replied
2
Reply
I'm happy to help. Thanks for the support!
0
Reply
Boosted
I printed this and it fits perfectly on my normal width rolls. Would you be able to make another version of the threaded part about 3/4 to an inch longer. I have a few larger rolls and the threads don't stick out enough to screw on the retaining nut. That's my issue, but as far as this print goes it printed perfectly and just works. Thanks!
The designer has replied
2
Reply
No problem. I added another bigger pin to the STL Download, tell me if it was enough.
Thanks for your support!
1
Reply
Boosted
I appreciate it, I'll try and print it again tomorrow. Just an FYI but I don't see an additional file in the Handy app. I'll have to check bambu studio on my computer tomorrow to see if it shows in there.
0
Reply
Replying to @user_632346796
This is my first model and I really haven't found how to change the .3mf file of my model, I don't think it's possible. So I added it as a new STL that you just need to download and add to Bambu Studio on your computer, if you don't know how let me know.
I made a test print and everything looks fine :)
1
Reply
love the idea just what I'm looking for except my prints seem to lock out the spool spring at the end as if the don't go deep enough and jam the center spool part up, and i can't put the back part back on not deep enough, am i missing something
The designer has replied
1
Reply
I believe you didn't remove the support. It comes off easily by holding it with pliers and rotating it. Once you remove all the support, the piece should go in easily.
0
Reply
Replying to @man0
yea thanks for that im the stupid one here just noticed was to keen to use but great design best yet thanks again
0
Reply
Replying to @POPPAESCOBA
No problem. Thanks for the support :)
1
Reply
Boosted
usefull
1
Reply
Big thanks for the video!! I would have never figured out how to get the print attached to the spool - lol
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works perfectly! Supports separated so easily.
1
Reply
Boosted
Great way to integrate with existing design!
1
Reply
Boosted
Perfect, Thanks for the easy and very well designed model!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld