Bambulab P1P P1S Slim poop chute
Copyright Claim
Bambulab P1P P1S Slim poop chute
Boost
17
36
15
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
17
36
15
1
128
100
Released
Description
Bambulab P1P P1S Slim poop chute
Good if you have a wall at the back
Comment & Rating (15)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Macht genau was es soll 5 Sterne weißes ESUN PLA
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
war gegangen. War mein Dritter Druck, out of the Box
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fits good but the poop does get stuck and does not fill the whole thing up.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very LIghtweight! Fits P1S rear corner like a glove!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints just fine!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
TOO thin
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld