Monochrome RX7 (Hueforge)
Monochrome RX7 (Hueforge)
Boost
14
21
9
Print Profile(2)
0.08mm layer, 1 walls, 100% infill
Designer
2 h
1 plate
0.08mm layer, 1 walls, 100% infill
4.1 h
1 plate
Open in Bambu Studio
Boost
14
21
9
0
36
22
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA PolyTerra Charcoal Black
PLA PolyLite Grey
PLA BambuLab Basic Jade White
Swap Instructions:
Start with Charcoal Black
At layer #8 (0.72mm) swap to Grey
At layer #16 (1.36mm) swap to Jade White for the rest.
Hueforge Affiliate: https://shop.thehueforge.com/?aff=6
Patreon: https://www.patreon.com/NeoKoiPrints
Youtube: https://www.youtube.com/@NeoKoiPrints
Tiktok: https://www.tiktok.com/@neokoiprints
Instagram: https://www.instagram.com/neokoiprints
Comment & Rating (9)
All
Print Profile
0.08mm layer, 1 walls, 100% infill
The designer has replied
0
Reply
Where did you get the model below the rx7??
0
Reply
Replying to @NeoKoiPrints
This model was created by me, but it is not very good quality. I will upload this model in better quality in the next few days. I have some models uploaded and I add new ones every day. If you like the models you can follow me.
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld