BambuLab P1S -Top Spool Holder
Copyright Claim
BambuLab P1S -Top Spool Holder
Boost
96
174
40
Print Profile(3)
0.2mm layer, 6 walls, 25% infill
Designer
8.4 h
3 plates
Heightened version for use with elevated shelves 增高版本 用于适用增高架
8.7 h
3 plates
Use printed screws 使用打印的螺丝 Please use 0.1mm for the height of the screw layer 螺丝层高请使用0.1mm
8.5 h
3 plates
Open in Bambu Studio
Boost
96
174
40
6
339
393
Released
Description
The spool holder has to be rotated 50 degrease to fit the print aera in Bambu Lab P1S.
(As a precaution both holder parts should be rotated 50 degrease to be sure that they match each other).
Plotprofil: Bambu PLA Basic
Preset: 0.20mm Strength @BBL X1C
- Wall loops: 6
- Sparse infil: 25% Grid
Bolts required:
4 x M3 20 mm thread + bolt head 2 mm high
2 x M3 12 mm thread + bolt head 2 mm high
Nuts required:
2 x M3 5,4 mm wide
Design: Søren Håkan November 2023
Copyright notes: Not for Commercial Use - Created in Autodesk Fusion 360 Personal
Comment & Rating (40)
All
Print Profile
Heightened version for use with elevated shelves 增高版本 用于适用增高架
An amazing model. I have been searching for a top holder for a while and this one hit all the requirements.
I printed the higher one without the M3 bolts and nuts, and also rearranged the screws to the other two plates.
The designer has replied
2
Reply
Thank you for your affirmation, the screws used in the printed tray bracket are not strong enough to fix the tray stably, so it is recommended to use metal screws
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
es ist perfekt und einfach
1
Reply
Boosted
printed really well even on sport mode with basic pla.
really happy with the result and how everything fits together !
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
it is little bulky. But the design works great!
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
very good profile. didn't touch anything and printed well on pla+
0
Reply
Top Konstruktion sehr gelungen
0
Reply
Print Profile
Use printed screws 使用打印的螺丝 Please use 0.1mm for the height of the screw layer 螺丝层高请使用0.1mm
Strength Issue:The printed screw doesn't really work. Just go buy some metal screw online. It will save you so much trouble
0
Reply
any way you could make it 1.25" taller? I really like this but can't because I have a riser with light strip installed
2
Reply
Could you considering simplifying your design to save more time and materials? Thank you.
1
Reply
Boosted
muy buendiseño
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld