This is designed to be printed with TPU filament.

If you do not have TPU, please print this version.

Acts as a dust cover for the opening in the top of the P1P and P1S.

Might help to prevent fumes and heat from escaping from the P1S when printing materials such as ABS and ASA.

Designed to fit snugly and has a notch at the front and back for easier removal.

Prints in roughly 11 minutes, using about 0.5 grams of filament.

• Print settings are very important, so please use the included print profile w/ a 0.4mm nozzle.
• Make sure your TPU is dry!
• This needs to be printed slowly - most of the speeds have been tuned to 30 mm/s.
• Optimized for 0.20mm layer height.

Installation:
Simply snap into place with your fingers.
If the fit is a little tight, try inserting the right side first and push down on the left side.