Keychain Hooks for HSW - 4 Sizes

Introduction

Hooks for storing multiple keychains or key rings. The notches stop the keychains from sliding around, and are spaced 10mm apart. The 30mm hooks have 3 notches, 60mm hooks have 6 notches, etc.

Designed to fit onto HSW (Honeycomb Storage Wall) boards. The display stand, if you were wondering, is here and a smaller one is here.

As usual, these are designed with no screws, no glue, no supports, no bridges and easy overhangs.

Material

• Suggest PLA, ASA, ABS, PETG-CF or similar stiffness materials.
• If you use PETG, the clip will be a little too easy to remove and
• If you use a stiff material like ASA-CF or ABS-GF, the clip will be difficult to insert/remove.

Print settings

• 2+ perimeters
• I suggest slowing down the outer walls to ensure the part comes out strong with consistent gloss level all around (but this is optional).
• This is a fairly easy print, everything else is up to you!

General precautions apply - ensure your build plate is clean (wash with hot water and dish soap and dry with a clean towel), add mouse-ears and/or apply some glue if you often have adhesion issues.

Support

If you would like to say thanks, please post a make and share here and on socials. You could buy me a few metres of plastic on Ko-Fi otherwise, please post a make and check out my other HSW models in this collection. If you are using these stands as a part of your business and are finding it helpful, please consider buying this price label model to support more projects like this.

Remixes with significant changes are very welcome.