Strong Print-in-place Boxes
Remixed by
Copyright Claim
Strong Print-in-place Boxes
Remixed by
Boost
32
64
12
Print Profile(2)
No Brim 0.16mm layer, 3 walls, 15% infill
3.9 h
1 plate
PiP Boxes - 0.2mm layer, 3 walls, 10% gyroid infill
4.8 h
1 plate
Boost
32
64
12
0
111
50
Released
Description
You can scale this up more but hinge will get looser.
Comment & Rating (12)
All
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
Коробка не закрывается. При попытке закрыть коробку она сломалась.
The designer has replied
0
Reply
The error is not in the profile. You can clearly see, even on the surface, that the filament is not calibrated or is poorly calibrated. This causes the hinges to become too connected and cannot work. Not nice to give only 1 star.
(Edited)1
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
👍weiter so
0
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
big one IS OK. small one (multiple Tests) not
0
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
The print could probably benefit from slowing down 10 to 20%, but overall a very easy print with no supports or brims
0
Reply
Hinges too tight, causing lid to break before use.
The designer has replied
0
Reply
Did you scale down? It usually pops loose safely. Sorry to hear that.
0
Reply
I will try scale up, in your description you said it gets looser. I printed this at the original scale.
0
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
best box ever
0
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
hinges were very bend resistant, more than the lid
(Edited)0
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
No Brim 0.16mm layer, 3 walls, 15% infill
0
Reply
No more
Related Models
© 2024 MakerWorld