fab

Nice Work, thank you. I take the little version. Filament used: Extrudr Neon Orange and Bambu White ASA for the holder. PLA Bambu Ice blue and Bavaria Bübchenblau for the funnel. Have some colors in your life.. ;-) Now the first drying-job started.....

perfect

TOP

At first I thought that the normal version would not fit into the SUNLU S2. However, it does fit with the opening facing downwards. ***star rating changed***

Printed in ABS. I had to scale down the lid to 99% in xy and printed it without support.

Printed with Bambu PETG

Printed great in PETG transparent/white combination!

Works perfect for drying silica gel in my Sunlu S4 filament dryer.

Great design! I printed mine with PETG because i haven't any ABS in stock. I'm confident that it will be able to withstand a good 24 hours at 70 degre without sagging. I printed pretty good but i struggled with the screwing cap. Normaly i dont run into issue with compensation but this time it simply doesn't fit anyway in. I simply did uniform scaled the cap at 98% and it screwed all the way in whitout any sanding. Also the place where the support was for the screw hole had to be sanded a bit because the interface left some dirt inside the thread. I did not tried drying desicant yet but i'm confidend that this will do the trick! Some might say that desicant will dry quicker inside an kitchen oven, but i prefer let this dry 24 hours inside my filament dryer than cooking the whole house for a couple hours. Next job is for printing the funnel so i dont loose my perls ;)