Search models, users, collections, and posts
Bowden Clip
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Open in Bambu Studio
Boost
8
7
0
0
25
2
Released
Description
The original cable management twisters on the CR-6 SE are trash and don't hold anything. I wanted a bowden tube cable clip for my Creality CR-6 SE. Since the hotend-cable is flat, I couldn't find an existing design that would fit.
This clip is designed for Capricorn tubing but should also work on the preinstalled one. The fit right off the bed is really strong. If it doesn’t open wide enough to go over the tube you can first manually open the clip a bit until you hear a little „click“. After that it should just snap on. I appreciate any kind of feedback.
Print Settings
Printer Brand:
Creality
Printer:
CR-6 SE
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
20%
Filament:
SpiderMaker PLA Matte Black
Category: 3D Printer Accessories
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)