BambuLab P1S P1P Micro SD Card Dust Cover / Plug
Copyright Claim
BambuLab P1S P1P Micro SD Card Dust Cover / Plug
Boost
12
27
6
Print Profile(2)
PLA, 0.1mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
TPU, 0.1mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Open in Bambu Studio
Boost
12
27
6
0
12
14
Released
Description
There are print profiles included for PLA and TPU.
Please choose the correct one, because the geometries are slightly different.
Simple dust cover for the Micro SD card slot.
Designed to fit snugly when there is an SD card inserted in the printer.
Prints in a little under 10 minutes, using about 0.3 grams of filament.
- Print settings are very important, so please use the included print profile w/ a 0.4mm nozzle.
- If using TPU, make sure it is dry!
- This needs to be printed slowly - most of the speeds have been tuned to 30 mm/s.
- Optimized for 0.10mm layer height.
Installation:
Push into place into place with your fingers. The SD card should fit inside the notched out section.
Be gentle, you you might accidentally “eject” the SD card.
Comment & Rating (6)
All
Print Profile
PLA, 0.1mm layer, 2 walls, 15% infill
Printed well, it isn't as secure as I thought it was going to be. It rests on top of the microSD card instead of being a press fit.
The designer has replied
0
Reply
Yes, sometimes printing really small parts like this can be difficult due to variance.
Maybe try scaling it by a small amount like 0.2%
0
Reply
Print Profile
PLA, 0.1mm layer, 2 walls, 15% infill
Nice addon
1
Reply
Print Profile
PLA, 0.1mm layer, 2 walls, 15% infill
Perf! nice one.
0
Reply
Print Profile
PLA, 0.1mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
PLA, 0.1mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld