Came across this picture looking for hueforge ideas for Independence Day. Looked like it would be a good one. Hope you enjoy!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 200x133.5mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA+ AF American Blue Transmission Distance: 1.2
PLA+ AF American Red Transmission Distance: 3.1
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Matte Ash Gray Transmission Distance: 0.4
PLA BambuLab Basic Gold Transmission Distance: 2.9
PLA BambuLab Basic Jade White Transmission Distance: 3.2
This print uses 6 unique filaments

Swap Instructions:
Start with American Blue
At layer #7 (0.72mm) swap to American Red
At layer #9 (0.88mm) swap to Blue Gray
At layer #12 (1.12mm) swap to Ash Gray
At layer #18 (1.6mm) swap to Gold
At layer #20 (1.76mm) swap to Jade White for the rest.