We love the story of the Deathly Hallows and the Tale of the three brothers in Harry Potter and I wanted a Litho Lamp for it, so here ya go.
This uses LED strip lights as thats what I typically have a lot of and wanted to put them to use.
Items needed for the Lamp (standard items for lightboxes):
- 12"+ LED light strip
- LED terminations to plug into switch
- Inline switch
- power supply for LED
Instructions:
- Remove sticky from LED and insert the end into the Gap at the top of the “Light Stick” printed part.
- Wrap the LEDs around the stick towards the Cutout at the bottom of the Stick and thread the wire through the internal channel of the Lamp
- Secure the wire by placing the "Wire Access" cutout printed part into the back channel. (this is a snug fit- make sure you're done before pushing too hard to close it!
- Connect wiring, switch and power supply
- Place Litho into the Lamp Base cutout being sure not to pinch the cable and Enjoy!
-------------------------
In case you want to print your own Litho - use the following dimensions to fit the lamp base:
-Bulb Fitter:
-Height 12mm
-thickness 4mm
-Diameter 20mm
Connector:
-Height 12mm
-Width 5mm