Modern Self Watering Planter
Modern Self Watering Planter
Boost
3
17
1
Print Profile(2)
Planter v2 (50 degree angle) -0.2mm layer,3 walls,15% infill
Designer
5.9 h
2 plates
Planter v1 (45 degree angle)- 0.2mm layer,3 walls,15% infill
Designer
6 h
2 plates
Open in Bambu Studio
Boost
3
17
1
0
7
5
Released
Description
This is a self watering planter that works for a lot of flowers and herbs. The design was inspired by IKEA SATSUMAS self watering planters. The original size of the planter is: 120mm diameter and 120 height.
Since it is intended for use in direct sunlight I recommend using PETG, but some PLAs will work as well. ABS is not gonna last in my experiance.
Comment & Rating (1)
All
PLA is actually quite UV resistant. PLA being weak in direct sunlight is mostly related to heat issues (ex. getting too hot and bend under load) rather than UV related material degradation.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld