Mini airplane 2.5
Copyright Claim
Mini airplane 2.5
Boost
39
62
13
In Contest
Beach & Pool EssentialsPrint Profile(1)
0.08mm layer, 2 walls, 80% infill
Designer
23 min
1 plate
Boost
39
62
13
2
114
89
Released
Description
The wings must be printed in 3 layers, otherwise the plane does not fly well. check it out at BAMBU studioThe first layer must have a height of 0.12, for greater strength. other layers are set to 0.08mm. Carefully remove from the mat so that it does not deform. Bend the rear wings below 90°. There are also elevators at the back, which need to be bent slightly. the ends of the large wings can also be bent, I recommend. Throw the glider up, then it flies far, suitable for years of use even in the wind.
Comment & Rating (13)
All
Print Profile
0.08mm layer, 2 walls, 80% infill
PETG printed with no issues, fly's okay, taking to church to give to kids
The designer has replied
1
Reply
beauty, only the wings are bent to the opposite side. the print is upside down
0
Reply
Replying to @Marek69
thanks, flipped it and flew again...flew about the same lol nice plane I'm sure the kids will enjoy!
(Edited)1
Reply
Replying to @kyriosyesous
thank you if you can try my other airplane models
0
Reply
Print Profile
0.08mm layer, 2 walls, 80% infill
great print
(Edited)
1
Reply
Flys great! thanks, my grandson will love it
The designer has replied
1
Reply
i have several types of airplane, look at my profile
0
Reply
Print Profile
0.08mm layer, 2 walls, 80% infill
didn’t fly
The designer has replied
0
Reply
please send photo
0
Reply
Print Profile
0.08mm layer, 2 walls, 80% infill
Sehr feine Flügel, die Biegekanten finde ich sehr gut.
1
Reply
Print Profile
0.08mm layer, 2 walls, 80% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 80% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 80% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld