This is a printer, filament and slicing profile combo to allow the best usage of the A1/mini pen holder

Change extrusion line thickness based on the one of your pen

You can also use small Maker's supply 2x4 magnets to hold the paper sheet well

Disclaimer: This uses modified gcode, even if it has been mostly tested I advise you to start a small test print and stand by your printer the first time, be also very careful with magnet placement to make sure your printhead doesn't ram into it

There is also a ~45mm offset down the Y axis, so keep that in mind

For image vectorization I recommend using this website https://picsvg.com/ or just inkscape

Also dear makerworld mods: as for the “Please detail how you remixed the original model. Otherwise, our moderators will remove your model.”, please don't as this expands undirectly on the creator product and I was directly allowed by them to post the profile as a remix