Have a rounded emoji box for your stuff - now the box itself says what's inside!
Use the customizer (see customize button above!) or OpenSCAD to adapt the emoji and sizes as needed!
Customize twice, with type set to:
Then load both “xxx_both.STL” and “xxx_textonly.STL” into Bambuslicer.
It will ask wether its a single object.
Press “yes”.
Then color the two parts as you want:
As the color change is only in the first few layers, the wipe tower is very small:
Have fun!
You can print the box without supports:
Note that the wiggle room between the top lid and the bottom container is by default zero. If your printer is not well calibrated, increase this value to e.g. .3mm, so the lid fits on the bottom container.