(Originally by jkim_makes, posted here according to original license. See full license details below).

My favourite espresso WDT tool (the one I keep coming back to, after trying quite a number!).

Posted here because:

• I keep wanting to print these, and it's so much easier from my phone if it's on Makerworld!
• I've experimented with a number of different settings, and this is my favourite combination so far.

If you print the round 58mm base as below, this is also compatible with my coffee organisation system :)

I've arranged the parts on several plates:

1. The round 58mm base, and the version with slightly larger holes for the needles, as I find this works every time. If you haven't calibrated your specific filament, this is definitely the one to print.
2. Hex base, with slightly larger needles holes as above.
3. Round base, smaller holes. If you haven't calibrated your filament, I don't recommend this one.
4. Hex base, as per #3 above.
5. All of the parts from the original design. Remove the parts you don't want to print.

1-4 above are all versions without the logo on the handle, as this is what I prefer. If you'd like the logo'd version, you can print it from plate 5.

Print Settings

• After experimenting with several versions, I've found it helpful to have ironing on for the base piece (my profiles above all include this). That's because a smoother finish is easier to clean!
• If you re-arrange things, don't forget to turn the handle and body pieces flat-side down (i.e hollow-side up), so you don't end up with messy insides! It won't screw together properly in this case.
• My profiles are set to .16mm layer height. This results in a cleaner inside. I've also found it works on 0.2mm, but I prefer the higher-quality print.