The A1 Anti-Skeet Feet!

If you A1 is anything like mine (and ill bet it is…) that bugger can boogy when its printing! So much so, that it'll kick its poop box outta the way and cock itself sideways on the bench I have.. YIKES!

So I made some Anti-Skeet Feet for it. So mines a bit different than most.. My design is simple and effective! I have about a weeks worth of printing with these simple little buggers and have had NO skeeting! The ole A1 just whips around, slapping out awesome prints, while not slowly wiggling its way towards a falling hazard!

Printing and installing is simple! you WILL need some soft fuzzy velcro! As seen in the pictures, Ive already given the dimensions of the fuzzy velcro so you can prep it while the model is printing. (NOTICE: Quanity of pieces in the picture is PER bracket.. Not PER pair.. so heads up)

Once complete, simply peel and apply the velcro to the inside of the bracket, and then you can fasten the bracket to your desk/bench! Dont wanna use screws to secure it?! NO PROBLEM!! Grab some good 3m adhesive foam tape and cut some thin slivers to apply on the bottom of your feet and then stick it down!!

Print, Enjoy and have peace of the mind!

Profiles included for the A1 mini, A1 fullsize, and also X1/P1 machines!